Description: The One Up Dropper Post Remote V2 is an aluminium remote with an oversized bearing and a super smooth action, it's unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The One Up lever mimics your R/H shifter's inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever. With no bleeding, the cable set-up is quick and easy. The cable clamps at the lever making shortening the housing length for clean routing a breeze. Unlike a hydraulically actuated dropper, there is no temperature sensitivity and if your remote gets damaged you can still lower or extend your post by removing it from your frame and pushing on the actuator by hand. One Up Dropper Post Remote V2 Features A better remote for any cable operated dropper No bleeding Quick and easy to set-up Kit includes cable and housing Compatible with all cable actuated dropper posts One Up Dropper Remote V2 Install Instructions 22.2mm Clamp Loosely attach the hinged clamp to your handlebar (Left side of brake for SRAM, Right side of brake for Shimano) Attach the remote body to the clamp using your preferred mounting hole. Torque the remote body to the clamp using a 3mm hex to 3 Nm Loosen the 22.2mm clamp and rotate the One Up dropper remote until the remote body is parallel to the brake lever Snug the 22.2mm clamp to 1 Nm max. Shimano I-Spec II (M9000, M8000, M6000 etc) Remove the lever mounting bolt completely from the left brake using a 4mm hex Depress the Push to Open button using a 2mm hex to fully open the brake lever clamp Remove the plastic spacer from the inside of the lever clamp Install the One Up I-spec II adapter into the lever clamp Loosely reinstall the brake lever clamp onto the handlebar Attach the remote body to the I-spec II adapter using your preferred mounting hole. Torque the remote body to the I-spec II adapter using a 3mm hex to 3 Nm Rotate the One Up dropper remote until the remote body is parallel to the brake lever. Torque the brake lever clamp to the manufacturer's recommendation Shimano I-Spec EV (12 speed XTR M9100, XT M8100, SLX M7100 only) Remove the lever mounting bolt completely from the left brake using a 4mm hex Depress the Push to Open button using a 2mm hex to fully open the brake lever clamp Install the One Up supplied T-nut into the curved recess on the hinged clamp Reinstall the brake lever clamp onto the handlebar Install the One Up supplied IS-EV adapter onto the T-nut Attach the remote body to the IS-EV adapter using your preferred mounting hole. Torque the remote body to the IS-EV adapter using a 4mm hex to 3 Nm Rotate the One Up dropper remote until the remote body is parallel to the brake lever. Torque the IS-EV adapter bolt to the brake clamp using a 4mm hex to 3 Nm. SRAM Matchmaker X Remove Brake lever mounting screw and hinged clamp using a T25 Torx Install the One Up supplied T-nut into the curved recess on the hinged clamp Reinstall the brake lever clamp onto the handlebar Install the One Up supplied Matchmaker X adapter onto the T-nut Attach the remote body to the Matchmaker X adapter using your preferred mounting hole. Torque the remote body to the Matchmaker X adapter using a 3mm hex to 3 Nm Rotate the One Up dropper remote until the remote body is parallel to the brake lever. Torque the IS-EV adapter bolt to the brake clamp using a 4mm hex to 3 Nm. OneUp Components OneUp Dropper Post Remote V2 Black - shop the best deal online on sportessentials.co.uk
